vortiitaly.blogg.se

Flatout flooring
Flatout flooring





  1. #Flatout flooring how to
  2. #Flatout flooring full

The popular flat sheens are lovely, but they have different properties than glossy finishes. Flat Out flat is not recommended for high-use areas such as cabinets and tabletops.They are engineered with different resin systems. For the smoothest result, apply with a spray gun.ĭo not mix Flat Out Flat and High Performance topcoats.Remove streaks by buffing with or fine-grade (220-320) sanding pad, or sanding well and re-coating.Use a large applicator, such as a paint pad, for larger surfaces. Wipe the wood grain using smooth, even strokes. To avoid streaking, apply a liberal amount of product and avoid using pressure and back-brushing.

#Flatout flooring how to

See our video: How to Prevent Streaking with Water Based Topcoat Tips to prevent streaking during hand-application

  • Remove dust with a vacuum, oil-free tack cloth or clean water-dampened rag before re-coating.
  • Finish sand between coats with a fine-grade (220-320) foam sanding pad to improve smoothness and adhesion.
  • If a faster build is desired over raw wood, use General Finishes Sanding Sealer for the first coat, followed by 2 coats of Flat Out Flat.
  • Visit this FAQ for more information on spraying techniques.

    #Flatout flooring full

    Wear a full filter respirator (NIOSH/MSHA approved) and work in a ventilated space.

    flatout flooring

    For narrow surfaces, reduce the fan pattern to 2-3" wide to reduce overspray. Overlap each pass 25% to conceal lines. On large, flat areas, use wet, even patterns 6-8" wide. Keep your gun at a 90° angle, 6-8" from the surface. See our general guide for spray tip sizes. HVLP: 1.1mm-1.3mm spray tip, medium air cap. Verify tip sizes with your equipment supplier. Spray application: Before spraying, strain topcoat through a fine-mesh filter. Spray wet films at 3-5-mil thickness.Hand application: Apply a liberal amount using a synthetic bristle brush, foam brush, pad applicator or roller with smooth, even strokes & light lap lines.Additional coats will not improve durability. Flat Out Flat contains more matting agents to decrease the sheen, and the finish can get cloudy when excessive topcoats are applied. GF assumes no liability for the improper use of these products. California Residents: Adding more than 2% of GF Extender will make the products non-compliant per SCAQMD Regulations. Increase open time, if needed, with 10-15% General Finishes Extender if allowed by local regulations. GF Extender will improve flow and leveling and increase open time, which is helpful in dry climates.Thin as desired with distilled water start with 5%, adding up to 10% by volume.Test for adhesion when applying over an existing finish.Stir topcoat thoroughly to reincorporate solids that have settled to the bottom of the can before and throughout the application process.Watch Flat Out Flat product overview video here.General Finishes Flat Out Flat Application Steps All of GF's White Paints, brushable or spray versions, do NOT require a topcoat. Any clear coat can become reactive over wood substrates or existing finishes causing tannin, stain or dye bleed-through. CAUTION: Do NOT use GF Flat Out Flat or any other clear coat, over white or light paints such as GF Milk Paint, or GF White Poly as it may cause yellowing.







    Flatout flooring